Often the defaultexpiry is not the same for all. Next, the SIP registry frequency must be adjusted too. The RTP protocole must be the most high about the priority than a SIP protocol, and more high than a FTP protocole. This QoS provides any informations to the switch or to the routers which gives the best priority for the RTP packets or SIP protocol. With a VoIP you have to use the QoS on your LAN. (50 by default if nothing is setting up into your config trunk).Ĭall-limit=2 gives a limit for 2 calls at your sip trunk if this parameter is included into your config trunk. Next, you may set a limit for your trunk. (Limited by you provider, and/or through your bandwidth).įor any handling of VoIP, you need to know : It's evident that you need to have a limit for each SIP trunk. # OpenSSH is to specify options with their default value where # The strategy used for options in the default sshd_config shipped with # When we also provide SSL we have to listen to theĪnd you want to edit it so that you take away the # from in front of port and to change the number after it to the number you desire like so : You change the number after listen and match it in the lines that follow later on after virtual host but for https you need to go to /etc/httpd/conf.d/ssl.conf Ive done over 10 installations and from personal experience ive learned that you should open:Ĥ569 (only if your using a IAX Trunk for the most part)Īnd if you want to use the https and ssh from an external location the best thing is to change the default values, i believe you can change it on the GUI but im not sure, the way i change it is by logging in through winscp via the ssh port because i dont have to memorize all the directories you can actually see them as opposed to putty.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |